Refining the leaves, separating into lobes.
| 09 November 2020 15:15
Imran - There is a lot of lobe-cutting! I've included the tools I used in the download (link above) and hopefully it will be obvious what I used for the cuts you are interested in.
| 09 November 2020 03:21
Hi Chris. Hope all is well. When you are cutting the lobes of the leaves, what sweep gouge are you using? Thanks
| 20 October 2020 06:49
Imran - The edges of some of the leaves drop down very close to the background - such as those at the bottom of the picture above; these can be undercut only slightly, a couple of mm. Other leaves end quite far from the background - such as you can se top right; these can be undercut more extensively. And there's a range in between.
There's a logic to what needs undercutting and how much that depends on the design. Have a go and you'll see how it all pans out.
| 19 October 2020 19:20
Hi Chris. Nice video. Not clear if you are also setting in and undercutting the posterior leaves (leaves opposite to the volute). I assume the 2 leaves you are seen working on in the video are higher than the leaves in the back. Thank you